Free Shipping on orders of $35 or more.
******************************
Use this Laser Texture Paper to transfer a design with your rolling mill or with Metal Clay products to your project.
******************************
2.5" x 6.5" Laser Texture Paper is larger than the size required for a cuff bracelet. Cut these one time use laser texture papers larger than the size of your metal with scissors. The large size of the laser paper provides excess texture that can be preserved for other projects.

For best results, use MyLaserPapers directly between your project metal and your mill's roller. MyLaserPapers will not harm your rolling mill in any way and can be used directly on the mill's rollers. They can't scratch or leave a mark as steel plates can.

HINT: Place your metal and MyTexturePaper between your mills rollers then crank down until you can't easily pull the paper and metal from your mill but not to the point you are crushing the paper. Mark or determine the setting of your mill then uncrank and remove your metal and paper. Next, set the mill to the setting you determined then a slight bit more (might be a notch or a quarter turn on your mill). Feed your metal and paper through the mill one time only.

IMPORTANT: Use a test piece and perform a test to "learn" setting for these papers prior to running your project piece.