Apr 9, 2024 · I've been focused on getting one axis working first. I was able to at least get a basic tune on a single loop using just the motor encoder. But ...

Oct 28, 2020 · I'm in the process of configuring the servos on my 3 axis router but I need to control them before progressing to Tommylight's servo tuning ...

Feb 3, 2024 · Hello, I have a weird old surface grinding machine with very low backlash in its axes. The main hydraulic axis works fine, ...

Aug 27, 2019 · I need an encoder for the spindle motor so I can achieve accurate threading. The motor is a 1hp 3phase motor, likely the original motor, too.

Mar 5, 2024 · Good morning everyone , My 3-axis xyz milling machine is equipped with stepper motors that work properly. However, sometimes it happens that the ...

May 6, 2024 · Hi, I have a Mesa 7i95 with, so far, 2 stepper motors and encoders and I plan to use it on an old plasma machine. Already set the software ...

Apr 2, 2024 · Yes, you can use encoders for feedback, even with a parallel port, but normally only 2 of them and at very slow speeds, depending on the encoder ...

Mar 28, 2018 · Hi to all, lately I am playing with optical encoders and DC motors, all taken from old printers. With arduino I have full control over them.

Feb 23, 2021 · Hi ... I'm trying to communicate a Delta servo motor with Ormec Servo drive , but always I got F7 error , due to Feedback error .